MagZero Technologies
Unit down? Call877.825.1766Trade or retailSign in
Quick orderOrder historyTrade accounts
Configure to order

TurboCor retrofit kit configurator

Answer the build questions below and we'll assemble your kit BOM and return a priced quote. Not sure on a field? Leave it blank — we'll confirm before quoting.

Start configuring

Kit configuration

Panels

Only centrifugal retrofits need this. Turbocor replacement chiller panels can typically be reused.

UL Panel Build Needed
Compressors
Power Supplies
New Low Voltage Power Supplies
EXVs (Electronic Expansion Valves)

MCS EXV drivers support two EXVs sharing one signal. MCS supports Sporlan, Alco, Danfoss valves. Danfoss drivers must use Danfoss valves.

Qty of Main EXV Drivers Needed
EXV Driver Voltage Requested
Economizer — Flash Tank
Flash Tank Exists
Qty of Flash Tank Drivers Needed
EXV Driver Voltage Requested
Economizer — Brazed Plate
Brazed Plate Exists
Temperature Sensor Needed
Pressure Sensor Needed
Staging Valves

EXVs for staging valves can be controlled by each compressor board.

EXV
Solenoids
Touchscreens

1080p screens can be reused in landscape or vertical. Square screens are not compatible.

New Touchscreen Needed
Screen Orientation
Mounting Style
Bezel Needed
Size Requested
Power Supply Requested
Hot Gas Valve
Hot Gas Type
EXV Driver Needed
EXV Driver Voltage Requested
Temperature Sensors — Water

10k Type 2/3, 20k, Daikin, Multistack, Smardt sensors can be reused. MCS sensors are 100k ohm and need replacement.

Liquid Line

Used to calculate subcooling and assist troubleshooting. Optional.

Flow Switches

Thermal dispersion preferred. A kit is needed per water side; water-cooled chillers need two.

Level Sensors
Relays
Your information